|
mazter
can't remember where i ordered the blade from, but if i find it will post. cost ov blade was 52$us if i remember correctly. very pleased with the quality of this blade.
the guard i hand filed out of a chunk of aluminum.
rigged a jig to set the bone in out of wood so i could use a drill press to get the angle just right for the tang(very important you only get one shot at it).used a counter-sinking bit to pre-drill the burr end for the nut(won't use this methode again cause it's very hard to match the color of the burr with the epoxy fill).
check out the knife i'm building now in "build it yourself".
__________________
knowledge is power
"so use it"
|