|
SMLE bolt removal
There's a small serrated push lever on the RH side near the front of the action slide . Push it down, open the action and pull it back just far enough to rotate the front of the bolt straight up from R to L. Then pull the bolt out. Reassemble in the reverse. Very simple actually. 
BTW shooting old corrosive ammo's no problem, just clean it thoroughly, but the old brass probably shouldn't be reloaded.
If the stuffs corrosively primed reloaded stuff, trash can it, don't shoot it.
Fact is I wouldn't shoot sombody elses reloads in it UNLESS ya trust em with yer life, which ya are!
Hnter
__________________
A retired bum, Opinionated Old Fart living happily in Free Wyoming.
Never go any where unarmed, it's your right as an American.
Only from my cold dead hands could you take my guns: C. Heston & I. Vote freedom first, last and always!
Molon Labe!
Life NAHC. NRA (Endowment).
Officer: Wyoming State Shooting Association,
Member: WSSA, Blue Ribbon Coalition (BRC), GOA, RKBA , JFPO.
Founder: Wyoming Off Road Vehicle Association: Access, access, access!
Fair public access for all to all public lands on or off wheels.
Tick (Pi$$) a liberal off TODAY and every day !! Elitests SUCK!
Last edited by hnter; 03-05-2007 at 09:53 AM.
|