|
depends on the powder.
i run each load dropped through the powder measure on the sclae when im im useing long stick powders.
4350s 4831s rl19s and such. these dont come to dropn even remotly close through the measure. each of these is fine tuned with the trickler on the sclae.
but h414 h380 maybe imr4831sc(shortcut) and the new ss (super short) powders through almost dead on right through the powder measure. i only check around every ten rds to make sure im still holding within 1 grain.
but i usualky hold to a few tenths.
|