[Contenderizer]

As usual, great info guys.

I think Ol Joe has a good point. Before investing in a new d-scale I'll try dumping some powder in the poise beam and dribble to requried amount (every load). It may not take as long as I think - once I get a system down.

Next, I'll visit Harbor Tools, based upon Skeet's luck with the scale he purchased there, and see what they have to offer.

As Rocky indicated, its consistency that I'm after.

By the way, one problem that I have is dropping a charge from the powder measure into scale. I always end up with some kernels on the table after they have bounced out of the pan. Try as I might, there are always some that get away. I could dump into the brass and then dump into the pan, but I'm sure several kernels are hung-up on the primer. OK, now maybe I'm being too anal.