Thread: Removing Lettering from an Octagon Barrel
View Single Post
  #2  
Old 01-29-2009, 05:16 PM
Larryjk Larryjk is offline
Registered User
  
Join Date: Jan 2008
Location: Rawlins, WY
Posts: 824
Unhappy Removing lettering from an Octagon Barrel
MtnMike2, I kow the problem and the only way besides a milling amchine is by draw filing. You can blend in the area where you draw file it, or just leave the lettering as is. It is six of one and............. You may be the only one that will see the low spot on the flat. I would leave the lettering as is until you want to go the route of a new barrel.
Reply With Quote