Hi all. I thought I would post a few vid's on reloadin just in case we have any body here either doin it or thinkin bout gettin into it, so here goes,,
I start by
cleanin the WW of the clips and all the junk and end up with
these. Then I use lee pro melting
pot. This is my set
up.
Then we have to make the bullets, so
here is how I do that part, we end up with
these.
Then we have to
resize em. (Had to put
this one in too)
Then we have to flare the case mouth and load the
powder.
Then, all that is left is to
seat the bullets in and were ready to go and try em
out.
This one shows how easy it is to
de-prim the spent brass.
Now we come to cleanin the
brass. On this one I talk to much,
This is the end of the
cleanin part.
Now we come to the
primin part. And I guess that's it for re-loadin.
Hope this helps some one as it was fun for the lil Wife and me to make.
From the "I'll finish it tomorrow Ranc, Good