|
|
#2
09-22-2008, 08:37 AM
|
||||
|
||||
|
That's easy. A good 215 cast SWC will do it all. You can get them from several commercial sources. I like Leadheads in Kansas, but there are others and you may even find them locally (saving shipping).
Don't forget to try some 41 Special loads, too. Just shorten the brass to 1.16" and read my piece on it for loads. You might also have to shorten the seating die so it will crimp the shorter brass, but that's a five-minute lathe job for any beginner machinist.
__________________
Freedom of the Press Does NOT mean the right to lie! Visit me at my Reloading Room webpage! Get signed copies of my Vietnam novels at "Baggy Zero Four" "Mike Five Eight" 
|
|
|
Threaded Mode