|
|
#7
09-02-2010, 08:57 PM
|
|||
|
|||
|
Bad thing about making brass for the AM..for best loading and longevity it is best to thin the inside of the case so you'll need a inside neck reamer of 429 size 430 is ok too. Good taper crimp is necessary Don't use 22-250 cases as they have too much body taper and you lose cases(did that many years ago. 243 and 308 are kinda best. They also have to be correct length as they headspace on the mouth of the case. Much much easier to buy 'em if ya can. Try Huntingdons too. They quite often have hard to find cases. After making so many cases for this in the past... Being the PITA that it is..buy 'em if ya can..
__________________
skeet@huntchat.com Democracy is two wolves and a lamb voting on what to have for lunch. Liberty is a well-armed lamb contesting the vote!" Benjamin Franklin 
|
|
|
Threaded Mode