|
|
#11
01-03-2011, 12:02 PM
|
|||
|
|||
|
Jon, the factory trigger probably won't be very good on a basic model. There are lots of ways to improve the trigger pull, though.
Improvements can range in price from little to as much as the rifle cost. Captain's recommendation of a Volquartsen hammer is a good start- there are other brands, too. A replacement hammer or sear (or both) is going to be at the low end , price wise. At the high end, Volquartsen and others make an entire replacement trigger assembly, trigger guard and all, that's a drop in- and costs as much as a new rifle. Consulting your local gunsmith isn't a bad idea- maybe a new sear and a bit of hand fitting would do the job- it did on mine.
__________________
“May we never confuse honest dissent with disloyal subversion.” Dwight D. Eisenhower "If the freedom of speech is taken away, then dumb and silent we may be led, like sheep to the slaughter" George Washington Jack@huntchat.com 
|
|
|
Threaded Mode