|
|
|
|
#1
11-01-2010, 05:47 PM
|
|||
|
|||
|
Why not form your own brass???????????? From 7 mm to 6.5 mm is very simple. Run the 7mm brass through your seating die and then your FL die and you have 6.5 brass ready to load. Your case necks will thicken when sizeing down but you will have no trouble with that unless you have a tight necked chamber.
__________________
Catfish 
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
