carbide sizing dies question

[Jack]

Dovehunter, are you using a standard neck die, or the precision neck sizer with interchangeable bushings?
I agree with Larry's procedure, and that's what I do with a standard neck sizer die.
With the fancy neck die with interchangeable bushings, you can get the bushings in titanium nitride, and you don't need lube with those.
With most neck dies that have a decapping pin and expander button, even if you didn't have to lube the outside of the neck, you ought to lube the inside to ease the passage of the expander button.

[dovehunter]

Originally Posted by Jack

Dovehunter, are you using a standard neck die, or the precision neck sizer with interchangeable bushings?...

It is the standard neck sizer, not the one that uses the bushings. I think Larryjk was probably right in saying that one should follow the manufacturer's recommendations regardless. It really wasn't that much of an effort to do so. I also lubed the inside of each case neck.