12GA rifle From Hell--

[hubel458]

I found a few long brass 8ga cases to go with
the 3.3" plastic ones. They are an inch longer
and made by RMC. The 8ga barrel I'm putting
on a falling block will have the chamber long
so I can use both lengths of cases.
The plastic ones are from 8ga kiln cases with base
swaged a little and has shotgun primers, The
long brass has shotgun primers.
I use Fed 239 shotgun primers.Ed

[hubel458]

The long brass 8ga cases have same thick
sides as plastic cases. And there are long
plastic/paper cases out there, but they
are scarce. Thick sides mean a good chamber
fit, so as to minimize case expansion and make sizing
easier. Here is picture 8ga and 10ga fullbore slugs with
locked on basewads that I setup. Wads held on by
screws and slugs hollowbase as well, so to work in
smooth barrels with some accuracy. 8ga is 1100gr.
10ga is 900 gr.Ed