Cerakote Air Dry Coating

[Rapier]

410 Action L side before and after coating. Note that the coating is very thin, less than .001 so unlike other coatings it does not cover pits.
Ed

[Rapier]

This is the 410 barrel, long and up close. Note the pits in the close, right at the front of the block, half way up the barrel. It looks like a line of lettering, but is actually the forend line. The gray look in places is the reflection of the flash, it is Graphite Black, real black.
Ed

[Rapier]

This is the 391 cap and barrel. The cap was rusted, the barrel had, had a choke tube laid on it in the case and the case closed, the choke scratched and gouged about 3 inches of barrel right in front of the gas port / spring area going to the muzzle, to the right in this case.

The cap turned out with a semi gloss finish from the top being sprayed several times as I coated the sides. So, were I to do the barrel again, I would coat it in a 4 point then go right on with a second 4 point while it was still wet.

I called the tec folks and they said this stuff will not stick to itself once it gets tack free, so a second coat must be applied when the first is wet. The cap is how it looks with a wet applied second coat.
Ed