question on how to find the right load

[scooterman27006]

so hp i can chamber the bullets and it will be fine if i have to push a little to get the bolt or barrel closed - the reason for the moly - seems that almost every bullet i have shot in most calibers - the moly really calms down how the rifle shoots and even in this case the 204 calmed down a lot but it sure does have room for improvement- plus i am really bad to get a barrel hot lol impatient i guess plus a lot of the barrels i have now are fairly new except a couple of old favorites - i can shoot right outside the back door so i dont have to go to a range or anything so i shouldnt be in a hurry- and i usually just push a patch through every 10 rounds or so to clean it and that has worked on the others - i cant figure out though if the factory stuff is so short in these two guns if that is part of my problem and i need to make them much longer even if they chamber hard and dont have much bullet in the brass or if i just need to try different powders since my bullet choices are very limited - with the 204 being fairly new i guess is part of my problem also - not many 20 cal bullets available that i can make longer - i have a little time this weekend and if i can get my hands on some different powder i will load a few and see what happens might even try some with the 2.25 and 2.3 col and see what happens