|
|
|
|
#1
10-12-2005, 01:40 AM
|
|||
|
|||
|
If the CASE shoulder is touching you need to set the shoulder back.
Are you neck or full lenght sizeing? If full sizeing did you turn the die down to touch the shell holder with the ram at TDC and then add 1/8 or so more turn to it? The expander ball could also be part of the problem. Have you lubed the insides of the case neck? the ball may be dragging and pulling the shoulder out after it`s been resized.
__________________
I must confess, I was born at a very early age. --Groucho Marx 
|
 |
|
|
Hybrid Mode
