|
|
|
|
#1
03-21-2011, 12:22 PM
|
|||
|
|||
|
I found a few long brass 8ga cases to go with
the 3.3" plastic ones. They are an inch longer and made by RMC. The 8ga barrel I'm putting on a falling block will have the chamber long so I can use both lengths of cases. The plastic ones are from 8ga kiln cases with base swaged a little and has shotgun primers, The long brass has shotgun primers. I use Fed 239 shotgun primers.Ed 
__________________
Ed Hubel 
|
|
#2
03-29-2011, 02:57 AM
|
|||
|
|||
|
The long brass 8ga cases have same thick
sides as plastic cases. And there are long plastic/paper cases out there, but they are scarce. Thick sides mean a good chamber fit, so as to minimize case expansion and make sizing easier. Here is picture 8ga and 10ga fullbore slugs with locked on basewads that I setup. Wads held on by screws and slugs hollowbase as well, so to work in smooth barrels with some accuracy. 8ga is 1100gr. 10ga is 900 gr.Ed 
__________________
Ed Hubel
|
 |
|
|
Hybrid Mode
