|
|
#9
08-22-2011, 05:40 PM
|
|||
|
|||
|
Well I did quite a bit of research and think I am going to go with a static converter. I found a dual range one good for 1/3 to 3/4 horse on the low side and 3/4 to 1 1/2 on the high side. Cost is 109 bucks delivered And I found a one horse 3 phase drill press that i can buy at a good price..run either with that thing.. Now for a small milling machine...uh uh..then I gotta learn how to run it
__________________
skeet@huntchat.com Democracy is two wolves and a lamb voting on what to have for lunch. Liberty is a well-armed lamb contesting the vote!" Benjamin Franklin 
|
|
|
Threaded Mode