25.06 Rem.

[skeet]

Originally Posted by captain2k_ca

I had decent results with the 120 partitions. And again with the hornady 117 sst.

I want to try the 110gr accubonds....but i am unable to find any!!!

Try www.shootersproshop.com They quite often have Nosler bullets at reduced prices Sometimes 2nds sometimes overruns. I buy many there... and if you are a vet they give a 10% discount. Probably to Canadians too. They should. I tried the SSTs and found them uninspiring except in my Kimber 30-06. The 165 gr shoots better than I can. A numb from the neck up friend can shoot under a half inch with it... well under. If I can stay under 7/8s I am perfectly happy. And it is a Classic Select grade with very pretty French Walnut. I bought it cause it was pretty and it turned out to be a great shooter. I just checked their site and out of stock but did have Nosler 100 gr Partitions with a price of 14.95 per 50. 115 gr Ballistic tips were 12.95 per 50. Decent bullet also. Great on Antelope

[captain2k_ca]

Unfortunately all reloading components are ITAR controlled and restricted to exporting to Canada. It is possible, bit special permits are required......It is not cost prohibitive.....

[captain2k_ca]

The 120gr partitions cost me a buck each....

Currently looking for some H4831....lol

[captain2k_ca]

Got 2lbs of H4831sc and 100 110gr accubonds locally. That was a hair over $200.....ugh.

[skeet]

200 bucks?? Even Canadian that is wayyy too expensive. I do understand things are a bit ....ummmm... different in Canada. Hope it shoots well for you. I've only used a little 4831 SC. Had to try it but have stuck with the old H since I already have it and the loads "worked" up.

[captain2k_ca]

Nosler bullets are extremely expensive here

So is powder.

Plus side....everything i have loaded will shoot under 2 inches at 100 yards. Down side....i cant seem to find a perfect load. H4831sc an the 110 gr SST showed promise. But i always get that 1 flyer.... :/

[skeet]

Holy Cow it should shoot an inch or so..maybe less. Older 77 or a Mark 2? Front action screw pulls back.. Make sure it is tight. Loosen up... put a piece of very thin plastic card stock right at the bbl receiver junction and retighten. May need two thin pieces..but try one first. Not credit card thick now. Thin plastic card. Reason for plastic is it will not absorb water. paper will. Can't hurt..worked on one of my 77s and on a #1 I had. If you can find a friend with the old H4831. If you have a Nosler loading manual look in it for good powders. The SST bullet shoots good in my 30-06. It is too lightly constructed for elk IMO but should be good for deer